Rain Bird LXME2 - Set Flow Actions; Current Flow Reading

Current Section: Flow Sensor 69 Navigation:
13.1.15 Set Flow Actions
There are 3 options available to Set Flow Actions during High or Low ow:
• Diagnose & Eliminate
• Shut Down & Alarm
• Alarm Only
1 Turn the controller dial to Flow Sensor
2 At the FLOW SENSOR screen, press the
key to select “Set FloWatch”, then press Next .
3 At the FloWatch screen, press the key to select “Set Flow Actions”, then press Next .
4 At the Action Under High Flow screen, press the and keys to set the desired option
to occur under High Flow, then press Next
5 At the Action Under Low Flow screen, press the and keys to set the desired option
to occur under Low Flow, then press Next
6 At the Re-enable time screen, press the and keys to set the desired number for
hours (from 0 to 23). Press the Arrow keys to navigate between the number setting
elds. Set the minutes (from 0 to 59).
13.1.16 Current Flow Reading
Occasionally it may be useful to check the current ow rate in a particular FloZone and how that
compares to previously learned or user input station ow rates.
1 Turn the controller dial to Flow Sensor
2 At the FLOW SENSOR screen, press the key to select “Set Current Flow Reading”, then
press Next .
3 At the View Current Flow screen, press the and keys to select the desired FloZone
number. Current and expected ow will show.
•
Expected ow is from previously user-entered or learned station ow rates. The deviation or percentage
comparison of current ow to expected ow will show so you can see how close each FloZone is to a High
Flow or Low Flow condition (see Setting Up High Flow and Low Flow for more details).