Current Section: INTRODUCTION 7
Navigation:
1.5 Valves (Stations)
Valves, or stations are controlled and operate according to irrigation programs.
The controller is programmed to send signals to valves, which open and close on a timed schedule.
When a program is nished, the controller shuts o that valve and provides electrical signal for the
second valve to open and so on.
1.6 Programming Overview
1.6.1 Programs
The controller opens and closes valves according to a program you set. Each program contains:
Watering Start Times
The time(s) of day when the rst station is programmed to begin watering; all other stations in the
program then follow in sequence. See “Set Start Times” for more details.
Station Run Times
The length of time in hours and minutes that each individual station is programmed to run. See “Run
Times” for more details.
Watering Days
The days of the week or calendar dates on which irrigation is allowed. See “Water Days” for more
details.
Programming Guide
Before you begin programming, ll out the Programming Guide, this is located at the back of the
Quick Start Guide.
Enter information about your system hardware and settings in the appropriate elds on the
Programming Guide.
1.6.2 Storing the Quick Start Guide
Return the Quick Start Guide to a permanent, safe location when you’re nished working with it. We
recommend hanging it on the hook inside the controller cabinet door as shown below.
1.6.3 Remote Programming
The LXME2 controller can be programmed while operating under battery power.
To Next Page
Loading...
Need help?
General
