Monitoring and Configuring the Printer
182
6
G Click [OK].
Note
❒ Auto Run may not work under certain operating system settings. In this
case, launch “Setup.exe” located on the CD-ROM root directory.
❒ If you are required to restart the computer after installing SmartDevice-
Monitor for Admin, restart the computer and continue the configuration.
❒ SmartDeviceMonitor for Admin supports following languages: Czech,
Danish, German, English, Spanish, French, Italian, Hungarian, Dutch,
Norwegian, Polish, Portuguese , Finnish, Swedish, Chinese Simple and
Chinese Traditional.
Changing the Network Interface Board Configuration
Follow the procedure below to change the network interface board configura-
tion using SmartDeviceMonitor for Admin.
A Start SmartDeviceMonitor for Admin.
B On the [Group] menu, point to [Search Device<TCP/IP>], and then click [TCP/IP],
[IPX/SPX] or [TCP/IP SNMPv3]. A list of printers using the selected protocol ap-
pears.
Select the protocol of the printer whose configuration you want to change.
If you are using TCP/IP SNMPv3, enter the user authentication.
C In the list, select a printer whose configuration you want to change.
D On the [Tools] menu, click [NIB Setup Tool].
A Web browser opens and the dialog box for entering the user name and
password for the Web Image Monitor administrator appears.
NIB Setup Tool starts when the network interface board is default. Follow the
instruction on the screen.
E Enter the login user name and password, and then click [Login].
For details about the login user name and password, consult your network
administrator.
F Configure settings using Web Image Monitor.
G Click [Logout].
H Quit Web Image Monitor.
I Quit SmartDeviceMonitor for Admin.
Reference
For details about Web Image Monitor, see p.173 “Using Web Image Mon-
itor”.
To Next Page
Loading...
Need help?
General