Installing the Printer Driver Using USB
41
1
Windows 2000 - USB
Important
❒ Installing a printer driver requires Administrators permission. Log on using
an account that has Administrators permission.
If the printer driver has already been installed, plug and play is enabled, and the
icon of the printer connected to the “USB” port is added to the [Printers] window.
If the printer driver is not installed, follow the plug-and-play instructions of the
printer to install it from the CD-ROM provided.
A Check that the power of the printer is off.
B Connect the printer and computer using the USB cable.
Connect the USB cable firmly.
C Turn on the power of the printer.
Found New Hardware Wizard starts, and USB Printing Support is installed
automatically.
D In the Found New Hardware Wizard display, click [Search for a suitable driver
for my device [recommended]], and then click [Next >].
E Select the [Specify location] check box, and then click [Next >].
F Insert the CD-ROM into the CD-ROM drive.
When Auto Run starts, click [Exit].
G Specify the location where the source files of the printer driver is stored.
If the CD-ROM drive is D, the source files of the printer driver are stored in
the following location:
•RPCS
D:\DRIVES\RPCS\WIN2K_XP\(Language)\DISK1
•PCL 5c
D:\DRIVES\PCL5c\WIN2K_XP\(Language)\DISK1
•PCL 6
D:\DRIVES\PCL6\WIN2K_XP\(Language)\DISK1
•PostScript 3
D:\DRIVES\PS3\WIN2K_XP\(Language)\DISK1
H Check the printer driver location, and then click [OK].
I Click [Next >].
J Click [Finish].
If the printer driver has already been installed, plug and play is enabled, and the
icon of the printer connected to the “USB001” port is added to the
[
Printers
]
window.
Note
❒
To disable Auto Run, press the left
{
Shift
}
key when inserting the CD-ROM into the
drive and keep it pressed until the computer finishes reading from the CD-ROM.
❒
The number after “USB” varies depending on the number of printers connected.
To Next Page
Loading...
Need help?
General