Understanding the Displayed Information
239
6
Note
❒ For details about UNIX commands and parameters, see UNIX Supplement.
❒ For details about mshell prnlog commands, see p.213 “prnlog”.
Configuring the Network Interface Board
Use the following command to display network interface board settings:
• telnet : Use the “show” command.
Result Print Request Result
Communication Result
•OK
Print was completed normally. However, the print result may
not be as required due to printer problems.
•NG
Printing was not completed normally.
•Canceled
An “rcp”, “rsh”, or “lpr” command print request was can-
celed, possibly due to the printing application. Not applicable
to the “ftp” or “rprinter” command.
Time Time the print requested was received.
Time of print request reception
User ID Printer driver-configured User ID.
Appears when the print request ID is specified.
JobName Name of the document for printing
Appears when the print request ID is specified.
Item Description
Common
Mode
Protocol Up/Down Protocol Settings
AppleTalk
NetWare
SMB
SCSI print
PictBridge
Device Up/Down Device Settings
Parallel
USB
Bluetooth
Ethernet interface
Item Description
To Next Page
Loading...
Need help?
General