Remote Maintenance by telnet
213
6
passwd
Use the “passwd” command to change the remote maintenance password.
❖ Changing the Password
msh> passwd
• Enter the current password.
• Enter the new password.
• Renter the new password to confirm it.
❖ Changing the Password of the administrators using the Supervisor
msh> passwd {Administrator ID}
• Enter the new password.
• Renter the new password to confirm it.
Note
❒ Be sure not to forget or lose the password.
❒ The password can be entered using up to 32 alphanumeric characters. Pass-
words are case-sensitive. For example, “R” is not the same as “r”.
prnlog
Use the “prnlog” command to obtain printer log information.
❖ Print logs display
msh> prnlog
• Displays 16 previous print jobs.
msh> prnlog “ID Number”
• Specify the ID number of the displayed print log information to display ad-
ditional details about a print job.
Note
❒ For details about displayed contents, see p.231 “Getting Printer Information
over the Network”.
route
Use the “route” command to view andcontrol the routing table.
❖ All route information display
msh> route get “destination”
• Specify the IPv4 address to destination.
“0.0.0.0” cannot be specified as destination address.
To Next Page
Loading...
Need help?
General