Using PostScript 3
293
9
E Enter the password using the scrool keys, and then press [OK].
A confirmation screen appears.
A confirmation screen will reappear if the password was entered incorrectly.
Press [OK] to enter the password again.
F Press [Delete].
After the file is deleted, the printer screen reappears.
Note
❒ Press [Cancel] to cancel the delete request.
❒ If you have already set a password in the printer driver, enter it to delete.
User Code
Use this to set a user code for print logging.
Enter a user code using up to eight digits. A user code identifies a group of users
and allows you to check the number of sheets printed under each code with
SmartDeviceMonitor for Admin.
The following table shows the tabs or menus where you can select this function.
Paper Size
Use this to select the size of paper you want to use.
The following table shows the tabs or menus where you can select this function.
Reference
For details about the paper sizes supported by this printer, see Hardware
Guide.
Mac OS Select the [Enable User Code] check box, and then enter a
user code in the [User Code:] box on [Job Log] in the print
dialog box.
Mac OS X Select the [Enable User Code] check box, and then enter a
user code in the [User Code:] box on [Job Log] in the print
dialog box.
Mac OS [Paper:] on the [Page Attributes] tab in the Page Setup dia-
log box.
Mac OS X [Paper Size:] in the Page Setup dialog box.