SM 3-25 G147
Replacement
Adjustment
3.8.4 DEVELOPER
1. Development unit (See ‘Development Unit’.)
2. Remove the development roller (See ‘Development Roller’.)
3. Tip out the old developer [A].
4. Turn drive gear [B] to ensure that no developer remains in the unit or on the
development roller.
 Dispose of the used developer in accordance with local regulations. Work
carefully to avoid scratching or nicking the development roller.
5. Pour approximately 1/3 of the developer [C] evenly along the length of the
development unit.
6. Rotate the drive gear [D] to work the developer into the unit. Repeat [C] and [D]
until all toner is in the unit and level with the edges.
7. Reassemble the development unit
To Next Page
Loading...
Need help?
General
