SM 3-29 G147
Replacement
Adjustment
3.9.2 TRANSFER BELT
1. Remove the transfer belt unit. (See ‘Transfer Belt Unit’.)
1. Belt drive gear [A]
2. Set screws [B] (
x2)
3. Lay on a flat, clean surface and fold the unit to release the tension on the belt [C].
4. Transfer belt [D]
 Avoid touching the transfer belt surface.
 Before installing the new transfer belt, clean all the rollers and shafts with alcohol to
prevent the belt from slipping.
 When reinstalling the transfer belt, make sure that the belt is under the pin [E].
 To avoid damaging the transfer belt during installation, manually turn the rollers and
make sure that the new transfer belt is not running over the edges of any of the
rollers.
To Next Page
Loading...
Need help?
General
