Firmware Update
SM 5-21 D117/D118
System
Maintenance
 The progress bar does not show for the operation panel firmware after you touch
"OpPanel". The power on key flashes on and off at 0.5 s intervals when the LCDC
firmware is updating. The power key flashes on and off at 3 s intervals when the
update is finished.
9. The "Update is Done" message appears on the operation panel after completing the updating.
The message differs depending on the firmware that has been updated.
10. Switch the copier main power switch off when you see the "Update is Done" message or
follow the procedure that is displayed on the operation panel.
11. Press in the SD card to release it. Then remove it from the slot.
12. Switch the copier on for normal operation.
Error Messages
An error message shows in the first line if an error occurs during the download.
The error code consists of the letter "E" and a number. The example above shows error "E24"
displayed. For details, refer to the Error Message Table (see "Handling Firmware Update
Error").
Firmware Update Error
If a firmware update error occurs, this means the update was cancelled during the update
because the module selected for update was not on the SD card.
To Next Page
Loading...
Need help?
General
