3. Print the image. Is the problem resolved?
Yes Finished!
No If this results in a paper jam during duplex printing, restore the previous setting.
• The adjusted margin cannot be applied to masked images that are solid-filled or contain ruled lines
at the leading/trailing edges.
• Reducing the leading/trailing edge margin may result in a paper jam on the fusing belt stripper
plate.
Curling
To eliminate curling without using the decurler unit, lower the heat roller temperature.
Lowering the temperature may result in:
• Unsatisfactory fusing
• Reduced glossiness
• Smeared for halftone images on uncoated paper
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Preparation.
Solution:
1. Select [Machine: Image Quality] in [Advanced Settings] for the custom paper in use,
select 1206: [Fusing Temperature] and reduce the value in [Heat Roller Temp] by 5
degrees.
2. Print a full-page solid-fill image. Is the problem resolved?
Yes Finished!
No Further reduce the value by 5 degrees until the problem is resolved.
If the problem persists, contact your service representative.
• To use the decurler unit, specify0310: [Correct Output Paper Curl] in the [Main Unit: Paper Feed/
Output] group on the [Adjustment Settings for Operators] menu.
Paper Feed Problems Affecting Image Quality
103
To Next Page
Loading...
Need help?
General
