2. Print the image. Is the problem resolved?
Yes Finished! If the problem also occurs on side 2 of the paper, perform the solution described
in "(b) If the problem occurs on side 2".
No Increase the absolute value of the negative current by another 5%.
3. Repeat Step 2. If the problem persists, contact your service representative.
(b) If the problem occurs on side 2
1. Adjust the setting for the side 2 of the paper. In [Advanced Settings] for the custom paper
in use, select [Machine: Image Quality] and increase the absolute value of [Side 2] by 5%
in 1203: [Paper Transfer Output].
Example: If the present current is −40 A, change it to −42 A.
2. Print the image. Is the problem resolved?
Yes Finished!
No Increase the absolute value of the negative current by another 5%.
3. Repeat Step 2. If the problem persists, contact your service representative.
Toner Scatter (2)
Parts of a line that is 5 mm (0.2 inches) or less from an image exhibit splatter.
3. Troubleshooting Image Quality Problems
32
To Next Page
Loading...
Need help?
General
