Solution:
Before you perform the solution procedure, make sure that the environmental conditions where you are
using the machine meet those recommended for use. For details on the environmental conditions for use,
see "Where to Put Your Machine", Maintenance and Management.
The solution depends on the interval.
• To adjust the following settings, pre-register the type of paper in use as a custom paper. For details
about registering custom papers, see "Registering a Custom Paper", Preparation.
Interval Solution
Approximately 12-18 mm (0.5-0.7 inches) Contact your service representative.
Approximately 60 mm (2.4 inches) Select [Machine: Paper Feed / Output] in [Advanced
Settings] for the custom paper in use and adjust the
set value of [Transfer Timing Roller] in 1351: [Motor
Speed] according to the paper type and thickness.
If the problem persists, contact your service
representative.
Approximately 95 mm (3.7 inches) Contact your service representative.
Approximately 314 mm (12.4 inches) Replace the photoconductor unit. If the problem
persists, contact your service representative.
• For details about replacing the photoconductor unit, see Replacement Guide.
Entire Image Faint
The entire image is fainter than normal.
3. Troubleshooting Image Quality Problems
52
To Next Page
Loading...
Need help?
General
