Scratches on the edge of the stapled paper occur
Cause:
Scratches of 10 mm may occur on the edge of the rear end of the paper when stapling the edge of the
paper.
Solution:
• A sponge mylar is not included. To use a sponge mylar, contact your service representative.
Paste a sponge mylar on the reference side of the reference fence.
Paper jam occurs while saddle stitching
Paper jam occurs when 21 or more sheets of 80 g/m
2
or less are stapled together.
Cause:
When the paper curls backward, paper deflection may occur during paper transferring in the booklet
staple unit and a paper jam may occur.
Solution:
Fix the paper by either of the following ways: "(a) Set the reverse side of the paper" or "(b) Adjust by the
decurler".
(a) Set the reverse side of the paper
1. Load the sheets the other way up.
2. Print the image. Is the problem resolved?
Yes Finished!
No Contact your service representative.
(b) Adjust by the decurler
1. In the [Main Unit: Paper Feed/ Output] group of [Adjustment Settings for Operators], select
0310: [Correct Output Paper Curl] to correct П curl.
Set the correction level to either "Correction Level: Small" or "Correction Level: Large"
according to the paper type.
Finisher SR5110/Booklet Finisher SR5120
153
To Next Page
Loading...
Need help?
General
