Solution:
Follow the procedure (a) " Resolving the problem according to the printed surface" first, and then follow
the procedure (b) "Resolving the problem according to the cause".
(a) Resolving the problem according to the printed surface
1. Pull the extension tray out from the finisher shift tray, and attach the SR5000 series
output tray for banner sheet.
2. In the [Finishing: Finisher 1] group on the [Adjustment Settings for Operators] menu,
select 0632: [Output Fan Setting].
3. Is the sheet delivered with the printed side facing down?
Yes Select [Output Fan Setting] to [Off].
No Select [Output Fan Setting] to [On].
4. Print the image. Is the problem resolved?
Yes Finished!
When all of the necessary printing is complete, configure [Output Fan Setting] back
to [Auto].
No Proceed to the procedure (b) "Resolving the problem according to the cause".
(b) Resolving the problem according to the cause
<Sheet end curling>
1. In the [Finishing: Finisher 1] group on the [Adjustment Settings for Operators]
menu, select 0632: [Output Fan Setting] to [Off].
2. Print the image. Is the problem resolved?
Ye
s
Finished!
When all of the necessary printing is complete, configure [Output Fan Setting]
back to [Auto].
No Go to the next step.
3. Print on a smaller number of sheets. If the problem persists, configure [Output
Fan Setting] back to [Auto] and contact your service representative.
<Sheet buckling>
1. Pull the extension tray out from the finisher shift tray, and attach the Z-fold
support tray.
Finisher SR5110/Booklet Finisher SR5120
149
To Next Page
Loading...
Need help?
General
