50 mm
(2.0 in.)
13 mm
(0.5 in.)
13 mm
(0.5 in.)
67 mm
(2.6 in.)
CZC313
Cause:
The invert exit drive rollers or invert exit idle rollers in the drawer are soiled.
This may occur if sheets are delivered face down after one-sided printing.
Solution:
Clean the rollers, sensors, and guide boards in the drawer.
1. Make sure that the system is turned off and the machine power cord is disconnected from
the power source.
2. Open the front covers.
3. Lower the levers C1 and C2, and then pull the drawer out completely until it stops.
3. Troubleshooting Image Quality Problems
24
To Next Page
Loading...
Need help?
General
