Installation Procedure
SM 1-13 J007/J010/J011
J007/J010/
J011
5. Load the stack with the print side facing down.
6. Make sure the top of the stack does not exceed the load limit mark.
7. Squeeze the paper guides and slide them to the sides of the paper stack.
The width side fences and bottom fence should not be too tight against the
sides and bottom of the stack.
If the stack bows upward, the fences are too tight.
8. Adjust the side fence positions so the top of the stack is perfectly flat.
To Next Page
Loading...
Need help?
General