Cleaning Procedures
SM 3-33 J007/J010/J011
J007/J010/
J011
3.5 CLEANING PROCEDURES
There are no printer parts that require scheduled maintenance or replacement. However,
the customer engineer should do the procedures described in this section when a service
call is requested.
3.5.1 SERVICE CALL PROCEDURES
Description At Service Call (or When Necessary)
External Covers Damp cloth.
Feed Roller Damp cloth. Release the feed clutch lock. Rotate the roller freely as
you clean it.
Friction Pad Damp cloth. This is the cork friction pad on the front edge of the
standard paper cassette (Tray 1).
Printer
Operation, Print
Quality
Print a Nozzle Check Pattern. Then check the results. Clean the print
heads if necessary. For more, see "Image Adjustment" in section "3.
Replacement and Adjustment".
Ink Collection
Tank
Replace when SC992 shows. The ink collection tank is full, or when
the display prompts that the printer needs maintenance. Open the
printer driver to confirm either condition. For more, see section "3.
Replacement and Adjustment".
Flushing Unit
Gate
Dry cloth. Always remove the ink that has hardened around the
flushing gate when you replace the ink collection tank. To remove
hardened ink, you may need to use a small screwdriver or similar
tool.
Maintenance
unit
Dry cloth. Always use a tightly wrapped dry cloth to remove the ink
that has hardened around the suction cap and wiper blade when you
replace the ink collection tank.
Maintenance
unit
Dry cloth. Always use a tightly wrapped dry cloth to remove the ink
that has hardened around the suction cap and wiper blade when you
replace the ink collection tank.
3.5.2 SERVICE TECHNICIAN RESPONSIBILITY
The responsibility of the service technician is limited because this machine is adjusted for
optimum performance at the factory before it gets shipped. Return the printer to the repair
center or replace the printer if a serious problem occurs.
To Next Page
Loading...
Need help?
General