Roland VS-2000 Owner’s Manual, Version Two Addendum www.RolandUS.com 77
8—VGA Main Display EZ ROUTING Screen
The VGA main display displays all four of the VS-2000’s EZ ROUTING screens at the
same time to make all of your routing simple to perform.
To display the EZ ROUTING screens, press EZ ROUTING on the VS-2000 or select
ROUTING VIEW from the EZ ROUTING menu (Page 32).
On the VGA main display, the VS-2000’s top-panel analog inputs and inputs and
outputs look just like their physical counterparts on the VS-2000 itself, making it easy to
visualize the input and output connections you’re making.
The F buttons beneath the EZ ROUTING screen are the same as those found on the
VS-2000’s internal LCD EZ ROUTING screens.
The LOAD and SAVE features behave as described in
Owner’s Manual
Chapter 22.
Making Connections
Routing on the VGA operates on the same principles as routing on the VS-2000’s
internal LCD. To learn about routing, see
Owner’s Manual
Page 232.
You can route signals on the VGA by:
• selecting the desired connection node with the
,
,
or
buttons and turning
the TIME/VALUE dial to make the desired connection.
• dragging the desired connections into place using your mouse.
Routing on the VGA Using a Mouse
To perform routing your mouse, position the mouse cursor over the desired
connection point until it turns into a pointing finger and then drag your mouse
to the desired destination.
PATCH
BAY view
pane
TRACK
ASSIGN
pane
OUTPUT
ASSIGN
pane
LOOP
EFFECT
ASSIGN view
pane
VS2000v2Add.book 77 ページ ２００５年４月８日 金曜日 午後２時２４分
To Next Page
Loading...
Need help?
General
