S&C 6800 Series User Manual

Introduction
2 S&C Instruction Sheet 1045-530
Qualified Persons
WARNING
Only Qualified Persons who are knowledgeable in the installation, operation, and
maintenance of overhead and underground electric distribution equipment, along
with all associated hazards, may install, operate, and maintain the equipment
covered by this publication. A Qualified Person is someone who is trained and
competent in:
• The skills and techniques necessary to distinguish exposed live parts from nonlive
parts of electrical equipment
• The skills and techniques necessary to determine the proper approach distances
corresponding to the voltages to which the Qualified Person will be exposed
• The proper use of special precautionary techniques, personal protective
equipment, insulated and shielding materials, and insulated tools for working on
or near exposed energized parts of electrical equipment
These instructions are intended ONLY for such Qualified Persons. They are
not intended to be a substitute for adequate training and experience in safety
procedures for this type of equipment.
Read this
Instruction Sheet
NOTICE
Thoroughly and carefully read this instruction sheet and all materials included
in the product’s S&C Instruction Handbook before installing or operating the
S&C 6800 Series Automatic Switch Control. Familiarize yourself with the Safety
Information and Safety Precautions on pages 4 and 5. The latest version of
this publication is available online in PDF format at sandc.com/en/support/
product-literature/.
Retain this
Instruction Sheet
This instruction sheet is a permanent part of your S&C 6800 Series Automatic Switch
Control. Designate a location where you can easily retrieve and refer to this publication.
The standard warranty contained in S&C’s standard conditions of sale, as set forth in
Price Sheets 150 and 181, applies to the S&C 6800 Series Automatic Switch Control, except
that the rst paragraph of the said warranty is replaced by the following:
(1) General: The seller warrants to the immediate purchaser or end user for a period of
10 years from the date of shipment that the equipment delivered will be of the kind
and quality specified in the contract description and will be free of defects of work-
manship and material. Should any failure to conform to this warranty appear under
proper and normal use within 10 years after the date of shipment, the seller agrees,
upon prompt notification thereof and confirmation that the equipment has been
stored, installed, operated, inspected, and maintained in accordance with the recom-
mendations of the seller and standard industry practice, to correct the nonconfor-
mity either by repairing any damaged or defective parts of the equipment or (at the
seller’s option) by shipment of necessary replacement parts. The seller’s warranty
does not apply to any equipment that has been disassembled, repaired, or altered by
anyone other than the seller. This limited warranty is granted only to the immediate
purchaser or, if the equipment is purchased by a third party for installation in third-
party equipment, the end user of the equipment. The seller’s duty to perform under
any warranty may be delayed, at the seller’s sole option, until the seller has been
paid in full for all goods purchased by the immediate purchaser. No such delay shall
extend the warranty period.
Special Warranty
Provisions

S&C 6800 Series Specifications

General

Brand	S&C
Model	6800 Series
Category	Controller
Language	English