Maintaining and servicing your device
7.4 Installing and removing hardware
SIMATIC IPC477D, IPC477D PRO
160 Operating Instructions, 11/2016, A5E31347228-AF
This chapter applies to devices with hard disk drive.
● The device is disconnected from the power supply.
● The device is open, see the section "Opening the built-in unit (Page 133)".
● Hard disk drive
● T10 screwdriver
Remove the marked screws.
Carefully remove the base
plate with the
hard disk fastened to it.
Remove the connector in the direction of
the arrow.
Detach the hard disk from the base plate.
Remove the four screws that connect the
hard disk and the base plate.
Note
Screws in various lengths
This procedure involves screws of various lengths:
Screws to fasten the SSD to the hard disk holder (short screws)
Screws to fasten the hard disk holder to the device (long screws)
Make sure you use the correct screws for each operation.
For installation, follow these steps in reverse and close the device.
To Next Page
Loading...
Need help?
General
