Description
1.7 Safety information
SIMOTION D410
28 Commissioning Manual, 02/2012
1.7 Safety information
Observe the following safety information when working with SIMOTION D410 and its
components!
CAUTION
The CompactFlash Card may only be inserted or removed when the SIMOTION D410 is
de-energized
The SIMOTION D410 is in a de-energized state when all the LEDs are OFF.
CAUTION
The 50 mm clearances above and below the components must be observed. The
ventilation openings may not be covered by connecting cables.
WARNING
Safe, problem-free operation of the SIMOTION D control unit assumes proper
transportation, storage, setup, and installation, as well as careful operation and
maintenance.
In addition to the danger and warning information provided in the technical customer
documentation, the applicable national, local, and plant-specific regulations and
requirements must be taken into account.
Only safety extra-low voltage in accordance with EN/IEC 60950-1 may be connected to all
connections and terminals.
To Next Page
Loading...
Need help?
General
