Siemens SINUMERIK 840DE SL Operation/Programming

6
08/2005 Working with Manual Machine
6.2 Zero-
p
oint offsets
6
♥ Siemens AG, 2005. All rights reserved
SINUMERIK 840D sl Operation/Programming ShopTurn (BAT) – 08/2005 Edition 6-335
6.2 Zero-point offsets
As an alternative to the "Set ZPO" function (see Sec. "Setting the
zero-point offset"), you have the option of inputting the values of the
zero-point offset directly into the zero-point offsets list.
Activating the zero-point
offset
 Select the "Work offset" softkey in the "Tools WOs" operating
section.
The work offset list appears.
 Position the cursor on the desired zero-point offset.
ZPO
Selection
 Press the "ZPO selection” softkey
6.3 Simple workpiece machining in manual mode
In "manual" mode, you can directly carry out simple machining
processes without having to write a program.
The following functions are available to you for machining in manual
mode:
 Axle movements
 Taper turning
 Straight (face or longitudinal turning)
Tool, spindle speed, and direction of spindle rotation are activated by
"Cycle Start".
A change in feedrate immediately becomes active.

Siemens SINUMERIK 840DE SL Specifications

General

Brand	Siemens
Model	SINUMERIK 840DE SL
Category	Control Systems
Language	English