Siemens SIPROTEC 7SJ62 Instruction Manual

Functions
6-57SJ62 Manual
C53000-G1140-C121-1
If a setting modification is not confirmed with the key, the original value reappears
after one minute, and a message window appears after three minutes notifying the
user that the setting modification period has expired. When the key is pressed, a
further message window appears, notifying the user that the setting modifications
were discarded. Further modification of settings is possible by pressing the key
and reentering the password.
Exiting the Setting
Modification Mode
If an attempt is made to exit setting modification mode using the key or the key,
the message $UH\RXVXUH" will be displayed followed by the responses <HV1R
and (VFDSH (see Figure 6-4). If the response <HV is selected, modification of settings
can be confirmed by pressing the key. To cancel pending modifications to settings
and exit setting modification mode, the response 1R must be selected. Press the
key until the response 1Ris highlighted. Press the key to confirm and exit. In-
correct entries may be retracted in this manner. To remain in the setting modification
mode, press the key until the response (VFDSHis highlighted. Press the key
to confirm, and the user can remain in setting modification mode without downloading
modifications .
Figure 6-4 Ending Setting Modification Mode Using the Front Control Panel
From PC with
DIGSI
®
4
Using DIGSI
®
4 to modify settings.
To select a function, the user should double-click on 6HWWLQJV, and then double-click
on the desired setting function (e.g., 3RZHU6\VWHP'DWD is selected by double-
clicking 6HWWLQJV, and then double-clicking 3RZHU6\VWHP'DWD as illustrated
in Figure 6-5).
ENTER
ENTER
ENTER
MENU
ENTER
ENTER
ENTER
ENTER
$UH\RXVXUH"
!<HV1R(VFDSH
ENTERENTER
6HWWLQJVDUHRN
!&RQWLQXH
:
www . ElectricalPartManuals . com

Siemens SIPROTEC 7SJ62 Specifications

General

Brand	Siemens
Model	SIPROTEC 7SJ62
Category	Relays
Language	English