Commissioning
7.3 5-minute quick start with the operator panel and the Ready-for-Use software
SIWAREX WP321
34 Manual, 07/2014, A5E33715669A-02
Selecting the calibration method
Figure 7-3 Quick start step 3
The module can always be calibrated in two different ways:
● Using reference weights: in the case of a calibration with weights, mechanical influences
of the scale construction are also partially taken into account.
● Without weights, using the technical specifications of the connected load cell(s): in the
case of automatic calibration, the accuracy of the scale is influenced by the mechanical
properties to a greater extent than with calibration using reference weights.
With both methods, make sure that the mechanical properties of the scale are flawless prior
to calibration.
To Next Page
Loading...
Need help?
General
