Siemens SIWAREX WP321 Manual

Scale parameters and functions
8.3 DR 3 calibration parameters
SIWAREX WP321
48 Manual, 07/2014, A5E33715669A-02
Variable
Note
Type
Length
(bytes)
Rw
Default
Min.
Max.
Standstill
waiting time
(Page 52)
Waiting time until standstill.
0: Any scale commands dependent
on standstill are rejected immediately
in the absence of standstill.
>0: Maximum waiting time until
command is executed
TIME 4 rw 2 000 0 10 000
Low-pass
filter limit
frequency
(Page 52)
Low-pass filter limit frequency:
0: Filter disabled
FLOAT 4 rw 0,5 tbd tbd
Low-pass
filter number
(Page 52)
Filter number 2*(1…5) USHORT 2 rw 4 2 10
Reserve Reserve USHORT 2 rw 0 - -
Reserve Reserve FLOAT 4 rw 0 tbd tbd
Reserve Reserve USHORT 2 rw 4 2 10
Mean value
filter depth
(Page 53)
Filter for digit values,
permitted filter depth: 0 … 250
USHORT 2 rw 10 0 250
1)
Parameter for calculation of calibration points
8.3.1
Scale name
You can select any name, but it may not exceed 12 characters. You can enter any
designation.
8.3.2
Unit of weight
A string with up to four digits can be specified as the unit of weight, e.g.: t, kg, lbs. The
defined unit of weight applies to all weight specifications. Entries are not be converted if the
unit of weight has changed. Entries must be left-aligned.
8.3.3
Gross identifier
The gross identifier specifies the letter, B (for brutto) or G (for gross), to be used in the
display for gross weights.

Siemens SIWAREX WP321 Specifications

General

Brand	Siemens
Model	SIWAREX WP321
Category	Accessories
Language	English