Scale parameters and functions
8.15 DR 32 Message display
SIWAREX WP321
Manual, 07/2014, A5E33715669A-02
79
Data record 32 indicates all pending message bits. The bit "Error status changed" is present
in the status bits of the DR30. If this bit is set, the message area of the DR32 has been
changed.
The DR32 indicates which message has been newly added or deleted. The data record is
automatically read by the SIMATIC FB in the event of an error. Following successful reading,
the status bit is reset in DR30.
Table 8- 13 Assignment of data record 32
Data record
number
Contains no. of data record USHORT 2 r 32 - -
Length Data record length information USHORT 2 r 26 - -
Application Information about which application the
data record belongs to
USHORT 2 r 101 - -
Version identi-
fier
Information on the current data record
version
USHORT 2 r 1 1 65 635
1000 Operator error BIT 2 r 0 0 1
Reserve - BIT r 0 0 1
1104 Undervoltage BIT r 0 0 1
Reserve - BIT r 0 0 1
1105 Overload BIT r 0 0 1
1106 Underload BIT r 0 0 1
1002 RAM error BIT r 0 0 1
1102 ADC error BIT r 0 0 1
1005 Hardware interrupt lost BIT r 0 0 1
1003 Checksum error data BIT r 0 0 1
Reserve - BIT r 0 0 1
1004 Checksum error program BIT r 0 0 1
Reserve - BIT r 0 0 1
1001 RESET / restart following error BIT r 0 0 1
Reserve - BIT r 0 0 1
Reserve - BIT r 0 0 1
2000 Technology error BIT 2 r 0 0 1
2001 Taring or zeroing timeout BIT r 0 0 1
Reserve (14
bits)
- BIT r 0 0 1
5000 Data or operating error exists BIT 2 r 0 0 1
5001 Command code or data record unknown BIT r 0 0 1
Reserve - BIT r 0 0 1
5003 Leaving calibration mode not possible BIT r 0 0 1
5004 Command or data transmission only
available in service mode
BIT r 0 0 1
To Next Page
Loading...
Need help?
General
