Suzuki GRAND VITARA XL-7 User Manual

ANTILOCK BRAKE SYSTEM (ABS) 5E2-33
Rear Sensor Rotor (Retainer Ring)
REMOVAL
1) Remove rear axle shaft assembly. Refer to “REAR AXLE
SHAFT” in Section 3E.
2) In order to remove sensor rotor (retainer ring) (2) from shaft
(1), grind with a grinder one part “A” of the sensor rotor
(retainer ring) as shown till it becomes thin.
3) Break with a chisel (1) the thin ground sensor rotor (retainer
ring) (2), and it can be removed.
INSTALLATION
1) Press-fit sensor rotor (retainer ring) (1) as shown in the fig-
ure.
2) Install rear axle shaft assembly. Refer to “REAR AXLE
SHAFT” in Section 3E.
CAUTION:
• Cover vinyl sheet (3) or the like over wheel bearing so
that fine grains from grinding will not enter there.
• Be careful not to go so far as to grind the retainer ring.

Suzuki GRAND VITARA XL-7 Specifications

General

Brand	Suzuki
Model	GRAND VITARA XL-7
Category	Automobile
Language	English