DIFFERENTIAL (REAR) 7F-5
Rear Differential Assembly
Dismounting
1) Lift up vehicle and drain oil from rear differential housing.
2) Remove rear brake drums and pull out right and left rear axle
shafts. (Refer to “REAR AXLE SHAFT REMOVAL” of Section
3E.)
3) Before removing propeller shaft, give match marks (1) on
joint flange and propeller shaft as shown.
4) Remove propeller shaft by removing its flange bolts and
nuts.
5) Remove differential assembly by removing its 8 fastening
bolts (1).
Remounting
1) Clean mating surfaces of rear axle and differential assembly
and apply sealant to axle side evenly.
“A” : Sealant 99000-31110
2) Install differential assembly to axle and fix it with bolts (1)
tightened to specified torque.
Tightening torque
Differential carrier bolts (a) :
55 N·m (5.5 kg-m, 40.0 lb-ft)
To Next Page
Loading...
Need help?
General
