9-20 BODY SERVICE
Rear floor carpet (without third seat vehicle)
REMOVAL
1) Remove rear luggage mat end garnish (1), rear side sill scuff
and rear quarter lower trims (2).
2) Remove luggage hook plate nut (3).
3) Remove rear floor carpet.
INSTALLATION
Reverse removal procedure for installation, noting the following.
Head Lining
REMOVAL
1) Remove front side sill scuffs (1), rear side sill scuffs (2), cen-
ter pillar lower trims (3), center pillar upper trims (4), front pil-
lar upper trims (5) rear luggage mat end garnish (6), rear
luggage box (7), rear quarter lower trims (8) and rear quarter
upper trims (9).
2) Remove rear A/C No.1 duct (1).
3) Remove sliding roof switch and sliding roof trim (if equipped).
4) Remove sun visor assembly (1)
5) Remove map lamp (2), dome lamp (3) and luggage lamp (4).
6) Remove assistant grips (5).
7) Disconnect rear washer hose and roof harness.
8) Remove head lining (6).
1
2
3
4
5
3
1
6
7
8
9
2
1
NOTE:
For without sunroof model.
Adhesive is used in head lining. Clear adhesive from
head lining and roof after removing roof lining.
12
5
5
3
4
6
To Next Page
Loading...
Need help?
General
