Steering / Handlebar: 6B-11
Tightening Torque Specifications
B931G36207004
NOTE
The specified tightening torque is described in the following.
“Steering / Handlebars Components (LT-A750XP/ZK9) (Page 6B-1)”
“Steering / Handlebars Assembly Construction (LT-A750XP/ZK9) (Page 6B-2)”
Reference:
For the tightening torque of fastener not specified in this section, refer to “Tightening Torque List (LT-A750XP/ZK9) in
Section 0C (Page 0C-7)”.
Special Tools and Equipment
Recommended Service Material
B931G36208001
NOTE
Required service material is also described in the following.
“Steering / Handlebars Components (LT-A750XP/ZK9) (Page 6B-1)”
“Steering / Handlebars Assembly Construction (LT-A750XP/ZK9) (Page 6B-2)”
Special Tool
B931G36208002
Fastening part
Tightening torque
Note
N⋅m kgf-m lbf-ft
Rear brake lever holder clamp bolt 11 1.1 8.0 )(Page 6B-4)
Handlebar clamp bolt 26 2.6 19.0 )(Page 6B-4)
Throttle lever case bolt 4 0.4 3.0 )(Page 6B-5)
Steering shaft lower nut 162 16.2 117.0 )(Page 6B-7)
Tie-rod lock-nut 29 2.9 21.0 )(Page 6B-9)
Tie-rod end nut 29 2.9 21.0 )(Page 6B-9)
Material SUZUKI recommended product or Specification Note
Grease Water resistance grease or
equivalent
P/No.: 99000–25160 )(Page 6B-7) / )(Page 6B-
7) / )(Page 6B-7)
Handle grip bond Handle Grip Bond (commercially
available)
— )(Page 6B-5)
Thread lock cement THREAD LOCK CEMENT SUPER
“1303” or equivalent
P/No.: 99000–32030 )(Page 6B-7)
09924–84521 09930–30721
Bearing installer set Rotor remover
)(Page 6B-6) / )(Page 6B-
7)
)(Page 6B-6)
09942–72410
Tie-rod end remover
)(Page 6B-6) / )(Page 6B-
8) / )(Page 6B-8)