Tektronix AFG3000 Series Reference Manual

Syntax and Commands
AFG3000 Series Arbitrary/Function Generators Reference Manual 3-51
[SOURce[1|2]]:FREQuency[:CW|:FIXed]
This command sets or queries the frequency of output waveform for the specified
channel. This command is available when the Run Mode is set to other than Sweep.
The setting range of output frequency depends on the type of output waveform. If
you change the type of output waveform, it might change the output frequency
because changing waveform types impacts on the setting range of output
frequency.
Group
Source
Syntax
[SOURce[1|2]]:FREQuency[:CW|:FIXed] {<frequency>|MINimum|MAXimum}
[SOURce[1|2]]:FREQuency[:CW|:FIXed]?{MINimum|MAXimum}
Arguments
<frequency>::=<NRf>[<units>]
where
<NRf> is the output frequency.
<units>::=[Hz | kHz | MHz]
Returns
<frequency>
Examples
SOURce1:FREQuency:FIXed 500kHz
sets the CH 1 output frequency to 500 kHz when the Run Mode is set to other than
Sweep.

Tektronix AFG3000 Series Specifications

General

Brand	Tektronix
Model	AFG3000 Series
Category	Portable Generator
Language	English