To Next Page

To Previous Page

Acquiring Waveforms

CSA7000B Series & TDS7000B Series Instruments User Manual

3-13

Overview Related control elements and resourcesTo set up signal input (Cont.)

Select input

coupling

4. Touch Vert to display the Vertical control window. To

change the input coupling, select the channel tab and

then select from:

H DC to couple both the AC and DC components of

an input signal

H GND to disconnect the input signal from the

acquisition

Touch Close to close the window.

Note. CSA7000B Series: If the O/E Electrical

Out--to--CH1 adapter is installed, the Termination,

Coupling, and Bandwidth selections are replaced with

Wavelength and Dark Level selections.

Set vertical

acquisition

window

5. Use the vertical knobs to scale and position the

waveform on screen.

Positioned vertically Scaled vertically

6. Touch Vert to display the Vertical control window.

To change the offset, touch the Offset control and

turn the multipurpose knob to adjust the offset.

Dragging the waveform

handle also positions

the waveform.

Tektronix CSA7404B User Manual

Other manuals for Tektronix CSA7404B