Fields in the Back Route Verify menu.
Field Description
Mode Select how the interfaces to be activated for Back Route Verify
are to be specified.
Possible values:
• , ! ,, !"#: Back Route Verify is activ-
ated for all interfaces.
• , ! #)"!" !"# (default value): A list
of all interfaces is displayed in which Back Route Verify is only
enabled for specific interfaces.
• .#, ! ,, !"#: Back route verify is dis-
abled for all interfaces.
No. Only for Mode = , ! #)"!" !"#
Displays the serial number of the list entry.
Interface Only for Mode = , ! #)"!" !"#
Displays the name of the interface.
Back Route Verify Only for Mode = , ! #)"!" !"#
Select whether ="7 @3 6!& is to be activated for the
interface.
The function is enabled with ,.
By default, the function is deactivated for all interfaces.
14.2 NAT
Network Address Translation (NAT) is a function on your device for defined conversion of
source and destination addresses of IP packets. If NAT is activated, IP connections are still
only allowed by default in one direction, outgoing (forward) (= protective function). Excep-
tions to the rule can be configured (in NAT Configuration on page 199).
14.2.1 NAT Interfaces
A list of all NAT interfaces is displayed in the Networking->NAT->NAT Interfaces menu.
Teldat GmbH
14 Networking
bintec Rxxx2/RTxxx2 197
To Next Page
Loading...
Need help?
General
