Chapter 3 Installation
Caution
Please read the safety notices carefully before installing and starting up your device.
These are supplied with the device.
3.1 Setting up and connecting
Note
All you need for this is the cable supplied with the equipment.
Caution
Incorrect cabling of the ISDN and ETH interfaces may also damage your device. Con-
nect only the ETH interface of the device to the LAN interface of the computer/hub or
an ISDN interface of the device, if any, only to the ISDN connection.
Note
If you connect an unconfigured device to an ISDN connection in parallel to a PBX, the
PBX cannot take any calls until an ISDN number is configured on the device. If no
entry is specified, every incoming ISDN call is accepted by the ISDN Login service.
3 Installation Teldat GmbH
6 bintec Rxxx2/RTxxx2
To Next Page
Loading...
Need help?
General
