Field Description
Trigger Select the state or state transition of Monitored Interface that
is to trigger a particular Interface Action.
Possible values:
• !" # 3) (default value)
• !" # 1
Interface Action Select the action that is to follow the state or state transition
defined in Trigger.
The action is applied to the Interface(s) selected in Interface.
Possible values:
• , (default value): Activation of interface(s)
• .#,: Deactivation of interface(s)
Interface Select the interface(s) for which the action defined in Interface
is to be performed.
You can choose all physical and virtual interfaces as well as op-
tions -,,  !"# and -,, *" !"#.
21.8.3 Temperature
Devices from the WI series are fitted with a temperature sensor. This is located on the main
board, under the first WLAN card.
The sensor measures the current temperature. Its measurement range is from -55 to +125
°C, with an accuracy of less than 1 °C.
In addition, the minimum and maximum temperatures reached are shown, together with the
times at which they were reached. These values are cleared and refilled upon rebooting the
device.
Lower and upper limits are set for the temperature by default; overstepping these sets an
alert variable and generates a syslog message. The values are updated every 10 seconds.
The temperature limits are configured in the Local Services->Surveillance->Temperature
menu. You can link the overstepping of a limit value with an action.
21 Local Services Teldat GmbH
482 bintec Rxxx2/RTxxx2
To Next Page
Loading...
Need help?
General
