Field Description
The default value is .
If you terminate the number entered with #, dialling is immedi-
ate.
Fields in the Advanced Settings menu.
Field Description
Speed Dialing Define short sequences of numbers that can be dialled instead
of the entire number.
Click Add to configure new speeddial numbers.
Enter the desired speeddial number for the user, e.g. $ under
Shortcut.
Under Replacement enter the subscriber number to be dialled
in place of the speed dial number, e.g. +$.
In the example above, if a user types in N$, the device dials
+$.
If the user wishes to call extension , he types in N$.
The device dials +$.
A period at the end of the number indicates a complete number.
This is dialled immediately the period is recognised.
If you want to use a speeddial number from this list, you must dial * followed by the speed-
dial number.
20.3 RTSP
In this menu, you configure the use of the RealTime Streaming protocol (RTSP).
RTSP is a network protocol for controlling multimedia traffic flows in IP-based networks.
Payload data is not transferred using RTSP. Rather, it is used to control a multimedia ses-
sion between sender and recipient.
If you want to use RTSP, the firewall and NAT must be configured accordingly. In the VoIP-
>RTSP menu, you can activate the RTSP proxy to enable requested RTSP sessions over
the defined port if required.
Teldat GmbH
20 VoIP
bintec Rxxx2/RTxxx2 427
To Next Page
Need help?
General
