Field Description
Strict), or the peer can also propose another mode.
Local ID Type Only for Phase-1 (IKE) Parameters
Select the local ID type.
Possible values:
• 93,,& D3,! . ' 9D.'
• , -##
• 6 -##
• -*'.' .# 3# '
Local ID Value Only for Phase-1 (IKE) Parameters
Enter the ID of your device.
For Authentication Method = .*- * 3, @*- *
3 or @*- "&) the Use Subject Name from certi-
ficate option is displayed.
When you enable the Use Subject Name from certificate op-
tion, the first alternative subject name indicated in the certificate
is used, or, if none is specified, the subject name of the certific-
ate is used.
Note: If you use certificates for authentication and your certific-
ate contains alternative subject names (see Certificates on
page 106), you must make sure your device selects the first al-
ternative subject name by default. Make sure you and your peer
both use the same name, i.e. that your local ID and the peer ID
your partner configures for you are identical.
Alive Check
During communication between two IPSec peers, one of the peers may become unavail-
able, e.g. due to routing problems or a reboot. However, this can only be detected when
the end of the lifetime of the security connection is reached. Up until this point the data
packets are lost. These are various methods of performing an alive check to prevent this
happening. In the Alive Check field you can specify whether a method should be used to
check the availability of a peer.
Two methods are available: Heartbeats and Dead Peer Detection.
18 VPN Teldat GmbH
346 bintec Rxxx2/RTxxx2
To Next Page
Loading...
Need help?
General
