Field Description
Default Route
If you enable the Default Route, all data is automatically routed
to one connection.
The function is disabled by default.
Local IP Address
Here, enter the (LAN-side) IP address that is to be used as your
device's source address for your own packets through the GRE
tunnel.
Route Entries
Define other routing entries for this connection partner.
Add new entries with Add.
• @ -##: IP address of the destination host or
network.
• '#7: Netmask for Remote IP Address If no entry is
made, your device uses a default netmask.
• %": The lower the value, the higher the priority of the
route (range of values ... ). The default value is .
MTU
Enter the maximum packet size (Maximum Transfer Unit, MTU)
in bytes that is allowed for the GRE connection between the
partners.
Possible values are to .
The default value is .
Use key
Enable the key input for the GRE connection, which makes it
possible to distinguish between several parallel GRE connec-
tions between two GRE partners (see RFC 1701).
The identification is enabled with ,
The function is disabled by default.
Key Value
Only if Use key is enabled.
Enter the GRE connection key.
Possible values are to +$+.
The default value is .
18 VPN Teldat GmbH
382 bintec Rxxx2/RTxxx2
To Next Page
Loading...
Need help?
General
