Field Description
Action Select the action to be applied to a filtered packet.
Possible values:
• -""## (default value): The packets are forwarded on the
basis of the entries.
• .&: The packets are rejected.
• @L": The packets are rejected. An error message is is-
sued to the sender of the packet.
Apply QoS Only for Action = -""##
Select whether you want to enable QoS for this policy with the
priority selected in Priority.
The function is enabled with ,.
The option is deactivated by default.
If QoS is not activated for this policy, bear in mind that the data
cannot be prioritised on the sender side either.
A policy for which QoS has been enabled is also set for the fire-
wall. Make sure therefore that data traffic that has not been ex-
pressly authorised if blocked by the firewall!
Priority Only for Apply QoS = ,
Select the priority with which the data specified by the policy is
handled on the send side.
Possible values:
• ' (default value): No priority.
• /1 /"&: Low Latency Transmission (LTT), i.e. hand-
ling of data with the lowest possible latency, e.g. suitable for
VoIP data.
• ? 
• %3
• /1
Teldat GmbH
19 Firewall
bintec Rxxx2/RTxxx2 387
To Next Page
Loading...
Need help?
General
