4.3 ODD Bay Module 4 Replacement Procedures
4.3 ODD Bay Module
Removing the ODD Bay Module (For Non-tray Module)
NOTE: The installation and removal procedures are the same for all the modules that
can be installed in the ODD bay. See the appropriate sections for the disassembly
procedures of specific modules.
Remove the ODD bay module according to the following procedures and Figures 4-8.
1. Turn the computer upside down.
2. Remove the two M2x4 black flat head screw.
3. Remove the ODD bezel.
4. Push out on the ODD bay module in the direction of the arrow.
CAUTION: Handle the ODD bay module carefully it can become hot during operation.
ODD bezel
ODD bay module
Push hear
M2x4 flat head screw
Figure 4-8 Removing the ODD bay module
Qosmio F40/F45 Maintenance Manual 4-21
To Next Page
Loading...
Need help?
General