4 Replacement Procedures 4.10 Top Cover
Installing the Top Cover
Install the top cover with the display assembly according to the following procedures and
Figures 4-20, 4-21.
1. Seat the top cover, adjusting its position.
2. Secure the following 10 latches on the top cover, in that order:
- Three Left latches
- Two right latches
- Three front latches
- two rear latches
3. Secure the top cover with one M2.5x8 black flat head screw.
4. Connect the touch pad board flat cables CN13 on the system board.
5. Connect the Bluetooth cable from CN15 on the system board.
6. Connect the FLICA flat cable from CN11 on the system board.
7. Connect the LED board flat cable from CN1000 on the system board.
8. Connect the volume board flat cable from CN9 on the system board.
9. Connect the switch board flat cable from CN16 on the system board.
10. Connect the speaker cable from CN3 on the system board..
11. Turn the computer upside down and secure it with the following 14 screws:
- Eleven M2.5x8 black bind screws
4-42 Qosmio F40/F45 Maintenance Manual
To Next Page
Loading...
Need help?
General