4 Replacement Procedures 4.5 Hotkey Board
4.5 Hotkey Board
Removing the Hotkey Board
Remove the Switch Cover and Switch Board according to the following procedures and
Figures 4-14.
1. Disconnect the switch board flat cables from CN4 on the system board.
2. Remove two M2.5x3 white flat head screws.
3. Disconnect the switch board flat cables from CN5000 on the switch board.
CN5000
CN4
Hotkey board
Hotkey board flat cable
Figure 4-14 Removing the hotkey board
4-30 Qosmio F40/F45 Maintenance Manual
To Next Page
Loading...
Need help?
General