12 Part Two
Enter the new setpoint of -
0.01300 in. W.C. Save the new setting.
Touch the Exit button in the Rm1 Alarm menu and again in the main menu to
return to the main running screen.
Menu and Menu Items
The PresSura Model RPC30 controllers are very versatile devices which can be configured to
meet your specific application. This section lists all of the menu items available to program and
change (except diagnostics menu). Changing items is accomplished by using the touchscreen or
through communications with the Building Automation System. If you are unfamiliar with the
keystroke procedure please see Software Programming section for a detailed explanation. This
section provides the following information:
Complete list of menus and all menu items.
Gives the menu or programming name.
Defines each menu item’s function; what it does, how it does it, etc.
Gives the range of values that can be programmed.
Gives default item value (how it shipped from factory).
The menus covered in this section are divided into groups of related items to ease programming.
As an example all set points are in one menu, alarm information in another, etc. The manual
follows the menus as programmed in the controller. The menu items are always grouped by
menu and then listed in menu item order, not alphabetical order. Figure 11 shows the PresSura
Model RPC30 controller menu items.
# of Rooms
Press Modes
Ctrl Devices
Rm1 Label
AnteRm Label
Display Meas
Display Avg
Units
Passcode
Num Format
Input 1
Input 2
Input 3
Input 4
Input 5
Input 6
Input 7
Room Mode
Neg Low Alm
Neg Hi Alm
Pos Low Alm
Pos Hi Alm
Exh Low Alm
Sup Low Alm
Temp Low Alm
Temp Hi Alm
Alarm Enable
ACH Duct
Room1 Vol
RH Low Alm
RH High Alm
Room Mode
Neg Low Alm
Neg Hi Alm
Pos Low Alm
Pos Hi Alm
Alarm Enable
To Next Page
Loading...
Need help?
General
