Phoning on several lines (multi-line) 105
Witness or tape connection
During a call a previously determined participant can be prompted to enter the
call as a “witness” via a programmed “Mithören Aufford” function key. The third
participant in the call is not informed of the connection of the “witness”. The wit-
ness can not participate in the call, only listen in.
Requirement: The witness or tape connection is set up on your system and the
programmed “Mithören Aufford” function key is set up on your phone. You are
conducting a call. “Privatgespräch” must be deactivated.
Press the programmed “Mithören Aufford” function key briefly twice. A special
ringtone sounds on the phone of the “witness” and the message “Zeugenzu-
schaltung” is shown on your display and that of the “witness”.
^ The “witness” lifts the handset,
or
presses the line/function key on which the call is being carried out.
The “witness” can now listen in to the call unnoticed.
Deactivating
Press the programmed “Rufumschaltung” function key. The LED goes out. A call
is again signaled on the phone.
Please take note of the applicable data protection regulations for the con-
figuration and use of witness or tape connection.
Mithören Aufford
_
Line 1
£
Only the “witness” can end the silent monitoring by hanging up or pressing
the line key.
Rufumschaltung
_
To Next Page
Loading...
Need help?
General
Weight and Dimensions
