OpenScape Voice functions 155
Parallel call
Managing number lists/activating parallel call
Before the parallel call feature can be activated, a parallel call list must be cre-
ated. This can be prepared either by administrator or you can create it yourself
later. Up to six numbers can be entered in the list for sites on which incoming
calls including your main number should be signalled sequentially. Each number
can consist of up to 30 digits.
^ Lift the handset.
j Enter the code for the edit mode (see code table ïƒ Page 163).
The edit mode opens and you hear an announcement with the following infor-
mation:
• Feature name
• Current status (active/inactive)
• Number of numbers currently on the parallel call list
You are prompted to do one of the following:
• Activate/deactivate the feature (only if numbers are already entered in the list)
• Call up the numbers currently entered in the list.
• Add or delete numbers
• Repeat the options in edit mode
If the parallel call list is still empty, you are prompted to enter numbers in the list.
As soon as you have entered a valid number, the parallel call can be activated.
If the parallel call is activated, incoming calls are routed to your phone and all
other destination phones in the parallel call list. The connection is established
with the first phone that accepts the call.
If the call is not answered by any phone, it is forwarded to the configured for-
warding destination (on no reply) or to a "rejection announcement".
Activating/deactivating parallel call via code
You can activate/deactivate the parallel call without having to change to edit
mode.
Prerequisite: You have already entered numbers in the parallel call list.
^ Lift the handset.
j Enter the code to activate or deactivate the parallel call (see code table
ïƒ Page 163).
To Next Page
Loading...
Need help?
General