C Applied Standards
This section describes relevant standards applied under the development of the robot arm and control
box. Whenever a European Directive number is noted in brackets, it indicates that the standard is
harmonized according to that Directive.
A standard is not a law. A standard is a document developed by stakeholders within a given industry,
defining the normal safety and performance requirements for a product or product group.
Abbreviations mean the following:
ISO International Standardization Organization
IEC International Electrotechnical Commission
EN European Norm
TS Technical Specification
TR Technical Report
ANSI American National Standards Institute
RIA Robotic Industries Association
CSA Canadian Standards Association
Conformity with the following standards is only guaranteed if all assembly instructions, safety instruc-
tions and guidance in this manual are followed.
ISO 13849-1:2006 [PLd]
ISO 13849-1:2015 [PLd]
ISO 13849-2:2012
EN ISO 13849-1:2008 (E) [PLd – 2006/42/EC]
EN ISO 13849-2:2012 (E) (2006/42/EC)
Safety of machinery – Safety-related parts of control systems
Part 1: General principles for design
Part 2: Validation
The safety control system is designed as Performance Level d (PLd) according to the requirements of
these standards.
ISO 13850:2006 [Stop Category 1]
ISO 13850:2015 [Stop Category 1]
EN ISO 13850:2008 (E) [Stop Category 1 - 2006/42/EC]
EN ISO 13850:2015 [Stop Category 1 - 2006/42/EC]
Safety of machinery – Emergency stop – Principles for design
The emergency stop function is designed as a Stop Category 1 according to this standard. Stop Category
Version 3.4.5
Copyright © 2009–2017 by Universal Robots A/S. All rights reserved.
I-61 UR5/CB3
To Next Page
Loading...
Need help?
General
