– Remove glove compartment ⇒ page 32 .
– Detach snap fasteners -2- from body.
– Pull out floor covering in front seat area -1- from below dash
panel, and pull it sideways out of vehicle.
Installing
Install in reverse order of removal, observing the following:
WARNING
Ensure that nobody is in vehicle.
– Connect earth wire at battery negative terminal ⇒ Electrical
system; Rep. gr. 27 ; Battery; Disconnecting and connecting
battery .
5.7.2 Removing and installing floor covering,
Multivan, passenger compartment
Removing
Note
If a rubber floor covering is fitted in the passenger compartment,
the respective replacement part is provided with the cut-outs for
the seats or seat rails. However, no provision is made for cut-outs
for additional installations, e.g. fastening rings. The potential cut-
outs are marked on the underside of the rubber floor covering.
Any cut-outs required for the specific vehicle must be cut using,
for example, the electric cutter - V.A.G 1561A- .
Special tools and workshop equipment required
♦ Torque wrench - V.A.G 1783-
♦ Torque wrench - V.A.G 1331-
Transporter 2016 ➤
General body repairs, interior - Edition 03.2020
5. Interior trims 245
To Next Page
Loading...
Need help?
General