3 Airbag system
WARNING
If the vehicle has been converted by ABT e-Line, it is possible
that the repair instructions provided below are no longer valid.
• In this case, please always refer to the repair instructions
from ABT e-Line, available in ElsaPro in the tab “Super‐
structures and modifications”.
⇒ “3.1 Overview of fitting locations - airbag system”, page 144
3.1 Overview of fitting locations - airbag sys‐
tem
⇒ “3.1.1 Overview of fitting locations - front airbag system”, page
144
⇒ “3.1.2 Overview of fitting locations - airbag system, curtain air‐
bag and crash sensors”, page 145
3.1.1 Overview of fitting locations - front airbag system
1 - Airbag unit on driver side
❑ Removing and installing
⇒ page 149
2 - Airbag warning lamp - K75-
in dash panel insert
❑ Removing and installing
⇒ Electrical system;
Rep. gr. 90 ; Dash panel
insert; Removing and in‐
stalling dash panel in‐
sert KX2
3 - Airbag unit on front passen‐
ger side
❑ Removing and installing
⇒ page 154
❑ Removing and installing
key-operated switch to
deactivate front passen‐
ger airbag ⇒ page 156 .
4 - Side airbag, front passen‐
ger side
❑ Removing and installing
⇒ page 158
5 - Side airbag, driver side
❑ Removing and installing
⇒ page 158
6 - Airbag control unit - J234-
❑ Removing and installing
⇒ page 146
Transporter 2016 ➤
General body repairs, interior - Edition 03.2020
144 Rep. gr.69 - Passenger protection