2.3 Routing and attachment of lines
WARNING
Risk of damage to lines
Lines may become damaged by moving or hot components.
♦ Route lines in their original positions.
♦ Ensure there is sufficient clearance to moving or hot com‐
ponents.
Note
♦
If electrical wires are disconnected or removed and installed,
it is useful to make corresponding drawings or photos. This
guarantees that everything is re-installed in its original posi‐
tion.
♦
Secure the electrical connectors which are routed through in‐
stallation openings using a wire or cord so that the electrical
connector can be guided through the installation opening dur‐
ing installation. Otherwise, the electrical connector may be out
of reach after installing.
♦
When using release tool - T10236- or removal lever - 80 - 200-
the wires can be removed more easily.
♦
Note wiring harnesses when removing components. Exces‐
sive tensile stress may cause damage.
♦
Before installing, all securing elements and attachments must
be checked for signs of wear and renewed as necessary.
♦
Route all of the various lines and electrical wiring in such a
way that they are restored to their original positions and the
wiring harnesses are not crushed.
♦
Fit all cable ties and other fasteners for wiring harness in the
same places from which they were detached or cut.
♦
Ensure that the electrical connectors are pushed fully onto
stop and engage audibly.
Transporter 2016 ➤
General body repairs, interior - Edition 03.2020
18 Rep. gr.00 - Technical data
To Next Page
Loading...
Need help?
General